This article discusses the outcome of an investigation of the failure of copper tubes from cold water distribution system carrying potable water in a shopping centre. Samples of copper tubes from a cold water distribution system which had failed due to pitting whilst in service were subjected to a detailed failure investigation. Analysis of the tubes showed that failure was a result of Type I pitting attack. While the exact cause of pitting was unknown, it was hypothesized that it could have been due to changes in the water quality and/or content. The tubes were found to be made from phosphorus de-oxidized copper and no anomalies were evident in either the chemical composition or the microstructure which could have caused the pitting observed. It was recommended that the tubes be replaced and that due attention be given to ensure that the new tubes are free of internal carbonaceous deposits or other foreign matter.
Reference:
Fernandes, PJL. 1998. Type I fitting of copper tubes from a water distribution system. Engineering failure analysis, vol 5 (1), pp 35-40
Fernandes, P. (1998). Type I fitting of copper tubes from a water distribution system. http://hdl.handle.net/10204/1625
Fernandes, PJL "Type I fitting of copper tubes from a water distribution system." (1998) http://hdl.handle.net/10204/1625
Fernandes P. Type I fitting of copper tubes from a water distribution system. 1998; http://hdl.handle.net/10204/1625.