ResearchSpace

Interpretation of single grain De distributions and calculation of De

Show simple item record

dc.contributor.author Jacobs, Z en_US
dc.contributor.author Duller, GAT en_US
dc.contributor.author Wintle, AG en_US
dc.date.accessioned 2007-01-20T12:24:56Z en_US
dc.date.accessioned 2007-06-07T10:09:51Z
dc.date.available 2007-01-20T12:24:56Z en_US
dc.date.available 2007-06-07T10:09:51Z
dc.date.copyright en_US
dc.date.issued 2006-03 en_US
dc.identifier.citation Jacobs, Z, Duller, GAT and Wintle, AG. 2006. Interpretation of single grain De distributions and calculation of De. Radiation Measurements, vol 41(3), pp 264-277 en_US
dc.identifier.issn 1350-4487 en_US
dc.identifier.uri http://hdl.handle.net/10204/1425 en_US
dc.identifier.uri http://hdl.handle.net/10204/1425
dc.description.abstract Recent development of an instrument for measuring the optically stimulated luminescence signal from individual mineral grains has made it practicable to measure the equivalent dose (De) from many hundreds or thousands of single mineral grains from a sample. Such measurements can potentially be used to address issues such as sample integrity, and to make it possible to obtain ages from samples that consist of mixtures of grains, enlarging the range of materials to which luminescence dating can be applied. However, for reliable ages to be obtained, the characteristics of the equipment and the sample being analysed need to be understood. Using sensitised sedimentary quartz grains, the instrumental uncertainty in repeated optically stimulated luminescence measurements made using a single grain laser luminescence unit attached to a conventional luminescence reader was evaluated; a value of 1.2% was obtained. Grains from this sample were then used to investigate the uncertainty in a measured dose distribution obtained using the single aliquot measurement protocol on each grain that had previously received a known laboratory dose; after systematic rejection of grains that did not pass defined acceptance criteria, over dispersion of 7% was found. Additional spread in data was found when uniform Aeolian sands were examined, resulting in over dispersion of ~ 12%; this was attributed to a combination of factors relating to differences in field and laboratory conditions. A similar value was found for an archaeological horizon below this sand. For another sample from the same section, a significantly larger value was found, ~ 29%; on this basis the finite mixture model was applied to obtain the likely dose components. The paper demonstrates the importance of correct assessment of error terms when analysing single grain De distributions and a number of rejection criteria that are vital to avoid the inclusion of data that could lead to misinterpretation of the degree of scatter present. en_US
dc.format.extent 1008630 bytes en_US
dc.format.mimetype application/pdf en_US
dc.language.iso en en_US
dc.publisher Pergamon-Elseveir Science Ltd en_US
dc.rights Copyright: 2006 Pergamon-Elsevier Science Ltd en_US
dc.source en_US
dc.subject Optically stimulated luminescence en_US
dc.subject Mineral quartz grain samples en_US
dc.subject Single aliquot measurements en_US
dc.subject Nuclear sciences en_US
dc.title Interpretation of single grain De distributions and calculation of De en_US
dc.type Article en_US
dc.identifier.apacitation Jacobs, Z., Duller, G., & Wintle, A. (2006). Interpretation of single grain De distributions and calculation of De. http://hdl.handle.net/10204/1425 en_ZA
dc.identifier.chicagocitation Jacobs, Z, GAT Duller, and AG Wintle "Interpretation of single grain De distributions and calculation of De." (2006) http://hdl.handle.net/10204/1425 en_ZA
dc.identifier.vancouvercitation Jacobs Z, Duller G, Wintle A. Interpretation of single grain De distributions and calculation of De. 2006; http://hdl.handle.net/10204/1425. en_ZA
dc.identifier.ris TY - Article AU - Jacobs, Z AU - Duller, GAT AU - Wintle, AG AB - Recent development of an instrument for measuring the optically stimulated luminescence signal from individual mineral grains has made it practicable to measure the equivalent dose (De) from many hundreds or thousands of single mineral grains from a sample. Such measurements can potentially be used to address issues such as sample integrity, and to make it possible to obtain ages from samples that consist of mixtures of grains, enlarging the range of materials to which luminescence dating can be applied. However, for reliable ages to be obtained, the characteristics of the equipment and the sample being analysed need to be understood. Using sensitised sedimentary quartz grains, the instrumental uncertainty in repeated optically stimulated luminescence measurements made using a single grain laser luminescence unit attached to a conventional luminescence reader was evaluated; a value of 1.2% was obtained. Grains from this sample were then used to investigate the uncertainty in a measured dose distribution obtained using the single aliquot measurement protocol on each grain that had previously received a known laboratory dose; after systematic rejection of grains that did not pass defined acceptance criteria, over dispersion of 7% was found. Additional spread in data was found when uniform Aeolian sands were examined, resulting in over dispersion of ~ 12%; this was attributed to a combination of factors relating to differences in field and laboratory conditions. A similar value was found for an archaeological horizon below this sand. For another sample from the same section, a significantly larger value was found, ~ 29%; on this basis the finite mixture model was applied to obtain the likely dose components. The paper demonstrates the importance of correct assessment of error terms when analysing single grain De distributions and a number of rejection criteria that are vital to avoid the inclusion of data that could lead to misinterpretation of the degree of scatter present. DA - 2006-03 DB - ResearchSpace DP - CSIR KW - Optically stimulated luminescence KW - Mineral quartz grain samples KW - Single aliquot measurements KW - Nuclear sciences LK - https://researchspace.csir.co.za PY - 2006 SM - 1350-4487 T1 - Interpretation of single grain De distributions and calculation of De TI - Interpretation of single grain De distributions and calculation of De UR - http://hdl.handle.net/10204/1425 ER - en_ZA


Files in this item

This item appears in the following Collection(s)

Show simple item record